Audio Microphones Conference System Flush Mount Boundary Microphone

Audio Microphones Conference System Flush Mount Boundary Microphone

VIS-BDY-F is a built-in microphone that makes the microphone hide on the desktop when not in use. This is achieved by simply pressing down on the top of the microphone until it locks. Then press the microphone again, and the microphone will rise back to its original position. This microphone can be used in the CLEACON Full-digital network conference system through the VIS-AIB analog connection box, or it can be used in the analog system, such as VIS-FS100-A automatic feedback suppressor, mixer, audio processor, etc.

Features

1.Low profile on any desktop or surface

2.The microphone is equipped with a reed switch, which is designed to switch at the beginning and end of each session when the microphone is no longer used. When the microphone is in the up position, the switch contact is closed (ON), and when it is retracted, the switch will be OFF.

3.Capacitive touch button can be optionally installed to easily set the microphone off or on for sound pickup.

4.Cardioid pattern.

5.Built-in microphone preamp power supply module, no need to use external power supply module

6.The sturdy all-metal structure design provides two layers of steel mesh cover protection

7.The microphone works from DC 11V to 52V phantom power.

8.Output with 3-pin XLR or 3.5 Phoenix connector

9.Built-in ring-shaped LED status indicator

10.Built-in RF filter

11.Equipped with shock-proof isolators to reduce vibration noise on the installation surface

Technical Parameters

Mic capsule ........ electrostatic capacitive type

Directivity Pattern ........ Cardioid

Frequency response ........ 40-19,000 Hz

Turn-on sensitivity ........    -40 dB (10 mV) at 1V at 1 Pa

Impedance ........ 200 ohm

High maximum ........ SPL 142 dB SPL, 1 kHz at 3% T.H.D.

Dynamic range ........ (typical) 113 dB, 1 kHz at highest sound pressure level

S / N....... 65 dB, 1 kHz at 1 Pa

Phantom power ........ DC 11-52V, power consumption 5.7 mA typical

Switch Touch control ........ On / Mute

Weight ........ 65 g

Overall ........ length 84.8 mm, diameter 38.0 mm, maximum width 48.0 mm

Output terminal ........ Built-in 3-pin XLR

Standard configuration ........ 1 pair of shock-proof isolator

System Diagram

Application