Before installing the faucet, everyone should pay attention to closing the main sluice first, otherwise, once the faucet is disassembled, the water sprayed out will affect the installation and use. Consider it in advance. After closing the main gate, use an adjustable wrench to unload the original faucet in a counterclockwise direction. Be careful to avoid damage to the water pipe. After using the old faucet for a long time, there will inevitably be some mud in the water pipe. Sand impurities, etc., don't rush to install the new Moen faucet, but first remove the impurities in the water pipe. It can be cleaned with a relatively soft brush to remove dirt, which can reduce the probability of future blockage of the faucet and ensure the water output of the water pipe. After cleaning, you can use raw material tape to wrap a few turns on the thread of the faucet, remember to follow the clockwise payout direction. This can effectively help reduce the possibility of water leakage. When installing Moen faucets, you must first have a basic consideration and follow the operating instructions. The installation of the faucet should also be tightened with the water pipe in a clockwise direction. What needs to be considered during the entire installation process is to prevent water leakage. It is recommended that you do not twist and twist too hard. After the installation is successful, open the main water valve and try to see if it can be used stably. After the installation of the faucet, the follow-up inspection work must also be done well, and everyone must do a good job of leak-proof inspection. Of course, when using the faucet for a long time, you should also pay attention to maintenance, do not force the switch, it will affect the use effect of the faucet, and it will also have a certain impact on its life. Take comprehensive consideration to support the long-term use of the faucet, with good safety and guaranteed use.