WALL SENSOR FL220

Power source: 100V/AC~277V/AC

Power frequency: 50~60Hz

Detection range: 180°

Detection distance: 9m(<24℃)

Working temperature:-20~40℃

Ambient light: 2~ 1000LUX(adjusted)

Working humidity: <93%RH

Time-delay: min:8sec±3sec max:7min±2min

Installation height: 1m~1.6m

Power consumption: 0.45W(static 0.1W)

Rated Load: 500W(220V/AC~240V/AC)

Detection motion speed: 0.6~1.5m/s

Touch-tone switch: AUTO, OFF, ON;

The product is the new saving-energy switch adopted the good sensitivity detector, integrated circuit and SMT. It gathers automatism, convenient safe, sawing-energy and practical functions. Three detectors inside compose a wide range detection field, they utilize the infrared energy from human as control-signal source to start the load at once when human enter detection field. And they can identify day and night automatically. It is easy to install and used widely, possessing the power show and detecting show functions.

Function:

ØDetection field: The wide range is made up of up and down, left and right service field. (See the following diagram 1), It has the relationship between the sensitivity and orientation of moving, please consider it carefully when you select the installation position;

ØIt can identify day and night automatically: This product has been adjusted to the maximum before leaving factory. But it also can be adjusted according to client’s desire;

ØDetection indication: The indicator lamp can flash one time when the sensor receives one signal to show the detection is regular;

ØTime-delay added continually: When it receive the second induction signals after the first induction, it could compute time once more on the rest of the first time-delay basic. (Set time)

ØTouching detection: The sensor will start the load when human touch the touching-line;( subjoined)

ØTime-delay adjustment: It can be set according to the consumer desire. The minimum time is 8sec±3sec,the maximum time is 7min±2min;

ØTouch-tone switch: AUTO, OFF, ON;

Installation (See the following diagram)

1.Shut off the power;

2.The power and the load wire are connected with the sensor according connection-wire diagram;

3.Lift the board-face off. Fix the sensor on the selected position with bolt;

4.You can connect the power to test it after covering the board-face and fixing bolt tightly.

Note: Do not connect the sensor into power directly!!!

Connection-wire diagram (See the right Fig)